Cutting piece balance

The cutting piece is widely used for its high efficiency, convenience, economy and other special properties, but many people neglect to make a reasonable selection of the cutting piece according to the occasion of their use, depending on the occasion of the thin flat cutting disc. The cutting discs can be divided into cutting and grinding types. Most of the cutting machines are fixed mobile, the power of the machine has high power and low power, and the cutting speed will also have high speed cutting and ordinary cutting. There are many kinds of materials to be cut during cutting, such as stainless steel, titanium alloy, ordinary just, sticky metal, high carbon steel, non-metal, etc. The performance requirements of the cutting piece are different for different occasions, so it is important to choose a reasonable cutting piece. To choose a good cutting piece according to the occasion you use, you can only have a more safety factor. The power of the cutting piece is small to reduce the radial frictional resistance, so that the cutting piece is thin and has a certain elasticity, and it feels sharper when cutting. The cutter piece must be statically balanced after it has been mounted on the flange. The static balance is to make the center of gravity of the cutting piece and its center of rotation. The specific static balance method is: the flange is placed on the mandrel and placed on the balance rail. If it is unbalanced, the heavier part of the cutting piece will always turn to the bottom, move the balance block position in the ring tip of the flange end face, balance the center of the entangled cutting piece, and repeat until the cutting piece is free on the guide rail. The position can be still, and the cutting piece reaches a static balance. After installing a new cutting piece for static balancing, attach the grinding machine to the shape of the cutting disc for stainless steel with a diamond pen, then remove the cutting piece and perform static balance for installation. Two static balances before and after can ensure better use of the cutting piece. If the cutting piece manufacturer does not perform static balance, it will cause the cutting piece to vibrate at high speed, which will affect the processing result. In severe cases, the cutting piece will be broken and the machine tool will be damaged. Therefore, the cutting piece must be statically balanced.